Ditto SES

System Status

Connection: Disconnected

Device Name: Ditto SES

RF Signal Monitoring Settings

Inactivity Timeout (sec):

Asynchronous Signal Timeline

LIVE

Pulses: 0 | Duration: 0 ms Silence: 0.0s

RX Configuration

Frequency (MHz):

Rx Bandwidth (kHz):

Modulation:

Receiver State & Telemetry

Active Freq -- MHz

Bandwidth -- kHz

Modulation --

            0
            Total Frames
          

            0
            Unique Frames
          

            0
            Missed / Corrupt
          

Captured Packets

No RX packets received yet. Enable connection and apply RX mode.

TX Global Settings

Tx Power (dBm):

Repeat Count:

Manual Signal Generator

Frequency (MHz):

Protocol:

Key Hex Payload:

Bit Length:

Pulse Te (µs):

EEPROM Stored Signals

Loading stored EEPROM signals from device...

Bruteforce Generator Configuration

Frequency (MHz):

Protocol:

Start Key (Hex):

End Key (Hex):

Pulse Te (µs):

Inter-packet Delay (ms):

Repeats per Code:

Execution Telemetry

IDLE

Current Key 0x000000

Transmitted 0

Remaining 0

Frequency Band & Calibration Offsets

Sub-GHz Frequency Band:

Manual Offset (FSCTRL0 / Hz):

Test Carrier Generator

Test Frequency Target:

Target Frequency (MHz):

Frequency Correction & Auto-Calculation

Measure the emitted carrier frequency with an external frequency counter or SDR, then enter the actual value below.

Measured Actual Frequency (MHz):

System Status

RF Signal Monitoring Settings

Asynchronous Signal Timeline

RX Configuration

Receiver State & Telemetry

Captured Packets

TX Global Settings

Manual Signal Generator

EEPROM Stored Signals

Bruteforce Generator Configuration

Execution Telemetry

Frequency Band & Calibration Offsets

Test Carrier Generator

Frequency Correction & Auto-Calculation

Save Signal to EEPROM